#X PLANE 11 KEY FOR SPEED BRAKES FULL#

It appears that it is intermittent and the only way I can clear it, is to exit XPlane and then reboot the computer. I came to a stop at the holding point on the taxiway and brakes locked up again. I was celebrating quietly after a good landing in the DDEN Challenger 300В using button 2 (rear Saitek yoke) for braking. I have changed to different aircraft (default and payware) and had the problem cleared. I have re-assigned V and B keys as well as a few others at different times. Is there something I can do to rectify this problem? I have tried to reconfigure the 'Brakes' button to other buttons but this does not seem to change anything either. I also note that regardless of the aircraft in operation once the parking brakes are released I cannot get them to re engage and have to hold down the brakes button continuously.

#X PLANE 11 KEY FOR SPEED BRAKES FULL#

Full power and the aircraft just stays stationary but yaws to the right. I checked the parking brake on the Pedestal and that is also disengaged. (I have a separate button allocated to Parking brakes set.) When I pressВ either button,В the 'brakes on' light (in the 550 aircraft) goes out. I have faulty Saitek pedals (rightВ side toe brake is not responding) so I have ignored both toe brake axis in settings and have assigned a yoke button to brakes until I fix the Rudder system. This problem applies to many aircraft including the Zibo 737s. I have read a lot of posts which tell me to release the parking brake using mouse and 'V' but nothing seems to work. Loading my Aerobask 550 engines started on runway when I release brakes and apply full power the aircraft does not move.

X plane 11 key for speed brakes